Baldor — Post Installation Checks
Installation · Complete generator set
From a Baldor service manual covering: GLC100, GLC125, GLC30, GLC35, GLC45, GLC50, GLC60, GLC80, MN2408. Check it applies to your exact model before use.
Applies to: Baldor (Baldor Generators / Baldor Electric Company) GLC100, Baldor (Baldor Generators / Baldor Electric Company) GLC80
Before you start
- Stop engine immediately if a fuel, coolant or oil leak is detected
Procedure
- Verify transfer switch is in Utility Power mode; no power present at generator.
- Verify engine starting battery is disconnected.
- Verify generator is securely mounted and anchored to its cement pad.
- Verify generator and transfer switch are properly grounded.
- Verify engine oil and coolant levels are full.
- Verify fuel source is ON with correct pressure and flow rate.
- Connect battery, start generator and check for fuel/coolant/oil leaks.
Tools required
- voltmeter Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Maximum ambient temperature 122°F (50°C)
Full service-parts list: Baldor (Baldor Generators / Baldor Electric Company) GLC100 →, Baldor (Baldor Generators / Baldor Electric Company) GLC80 →
Source: Baldor service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.