Home›Generac›Generac GP5500E

Generac GP5500E Generator Set

The Generac GP5500E is a 5.5 kW (6875 kVA) standby generator set powered by a Generac 5500E engine. It is available at 120/240 V, single-phase, 60 Hz and rated 45.8 A. It holds about 0.74 L (0.2 gal) of oil. The set measures 686×686×635 mm (27.0×27.0×25.0 in) and weighs about 75 kg (165 lb). An integrated tank holds 20.5 L (5.4 gal), roughly 13.4 hours of runtime.

5 kW
Standby
0.298 L
Displacement
0.74 L
Oil capacity
2
Document types

How to read your Generac serial & model number →

Service parts for the GP5500E

Grouped by system, with how many of each the parts manual calls for.

Air intake

1 required

Prices captured from merchant listings; some links are affiliate links. Confirm against your serial number before ordering.

Specifications

Frequency60.0 Hz
Standby power5 kW
Prime power5 kW
Oil capacity0.74 L
Voltage options120/240 V
PhaseSingle Phase
Rated current45.8 A
Circuit breaker30 A
Battery voltage12 V
Battery quantity1
Dimensions (L×W×H)686×686×635 mm
Dry weight75 kg
Fuel tank20.5 L
Tank runtime13.4 hr

Engine

Generac 5500E
Oil capacity0.74 L
Displacement0.298 L
Rated speed3600 rpm

Maintenance & consumables

for the Generac 5500E
ItemSpecCapacityPart #Interval
Air filter020423365 hr Amazon eBay $14.95
Fuel filter—100 hr
Oil filter—100 hr
Battery—365 hr
Belt—
Coolant—100 hr
OilSAE 30, 10W-30, Synthetic 5W-30—100 hr
Spark plugSeparation of electrodes: 0.70 to 0.80 mm (0.028 to 0.031 in)—200 hr

Common questions

What is the power rating of the Generac GP5500E?

The Generac GP5500E is rated 5 kW standby.

Which engine powers the Generac GP5500E?

The Generac GP5500E is powered by the Generac 5500E engine.

What is the oil capacity of the Generac GP5500E?

The Generac 5500E engine in the Generac GP5500E has an oil capacity of 0.74 liters.

How much does the Generac GP5500E weigh?

The Generac GP5500E has a dry weight of 75 kg (165 lb).

What size fuel tank does the Generac GP5500E have?

The Generac GP5500E has a 20.5 liter (5 US gallon) fuel tank, giving about 13.4 hours of runtime.

What voltage does the Generac GP5500E produce?

The Generac GP5500E is offered in 120/240 V, Single Phase-phase.

How many cold cranking amps does the Generac GP5500E require?

The Generac GP5500E uses 1 battery, 12 V each, per the manufacturer specification sheet.

What air filter fits the Generac GP5500E?

The Generac GP5500E uses air filter part number 020423.

Troubleshooting

6

Fault codes

CodeMeaning
000001DANGER
000103DANGER
000183Recoil Hazard

Symptoms & remedies

SymptomCauseRemedy
Engine is running, but AC output is not available.1. Circuit breaker OPEN. 2. Poor connection or defective cord set. 3. Connected device is bad. 4. Fault in generator. 5. GFCI receptacle is OPEN (if equipped).1. Reset circuit breaker. 2. Check and repair. 3. Connect another device that is in good condition. 4. Contact IASD. 5. Correct ground fault and press reset button on GFCI receptacle (if equipped).
Engine runs well at no-load, but bogs when load is applied.1. Short circuit in a connected load. 2. Generator is overloaded. 3. Engine speed is too slow. 4. Shorted generator circuit. 5. Clogged spark arrestor.1. Disconnect shorted electrical load. 2. Reduce load (see Know Generator Limits). 3. Contact IASD. 4. Contact IASD. 5. Clean spark arrestor screen.
Engine will not start; or starts and runs rough.1. Fuel shut-off is OFF. 2. Dirty air filter. 3. Out of fuel. 4. Stale fuel. 5. Spark plug wire not connected to spark plug. 6. Bad spark plug. 7. Water in fuel or cylinder overfilled. 8. Overchoking. 9. Low oil level. 10. Excessive rich fuel mixture. 11. Intake valve stuck open or closed. 12. Engine lost compression. 13. Engine switch is OFF.1. Turn fuel shut-off ON. 2. Clean or replace air filter. 3. Fill fuel tank. 4. Drain fuel tank and fill with fresh fuel. 5. Connect wire to spark plug. 6. Replace spark plug. 7. Drain fuel tank and fill with fresh fuel. 8. Set choke to no choke position. 9. Fill crankcase to correct level. 10. Contact IASD. 11. Contact IASD. 12. Contact IASD. 13. Turn engine switch ON.

Fault codes and symptom→remedy steps extracted from this model’s service/owner documentation; verify against the official manual before servicing. Full Generac GP5500E troubleshooting guide (15 entries) →

Parts

6
Part #DescriptionQtySystem
020422Handle Assembly (A)1Handle Amazon eBay
0K20670117Spark PlugSpark plug Amazon eBay $9.99
A0004457517-ABILINGUAL WARNING OF COWarning label Amazon eBay
A0006052083WARM EXHAUST LABELWarning label Amazon eBay
0H4635CPGMA Safety LabelService part / kit Amazon eBay
A0007276264COsense® ACTION LABEL1Service part / kit Amazon eBay

Service, wear & replacement parts referenced for this model and its engine — confirm the exact part for your serial number. See the full parts catalog to search and cross-reference.

Available documents

Spec sheet — 0Owner's manual — gp-series-owners-manual (Generac)

This page was generated from the 2 manufacturer documents above by automated extraction; every figure shown is copied from one of them. How the data is compiled.

Full service, cheapest listings

Priced items from this model's own parts manual.

Air filter 020423$14.95
1 priced item$14.95
Other sets with this engine