Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Caterpillar›Caterpillar Wheel Loader

Caterpillar Wheel Loader Generator Set

Caterpillar Wheel Loader generator set: . Specifications, engine details, filters, oil capacity and 3 document types.

3
Document types

How to read your Caterpillar serial & model number →

On this pageSpecsDocumentsProcedures

Specifications

Ratings spec sheet not in our library yet — see the documents below.

Procedures

4
Machine Shut Down operation
  1. Park the machine on smooth level area.
  2. Set parking brake.
  3. Lower all hydraulic implements.
  4. Run engine at low idle for 5 minutes to allow engine to cool.
  5. Turn key start switch to OFF and remove key.
  6. Dismount machine using 3-point contact.
  7. Block wheels and remove disconnect switch key if parking for extended period (pre OMM).
  8. Drain water from air tank, if equipped.
  9. Conduct post-operation walk-around inspection.
Machine Warm Up operation
  1. Allow machine to warm up (per OMM).
  2. Engage and disengage attachment controls to help speed warm-up of hydraulic components.
  3. Cycle all controls to allow warm oil to circulate through all hydraulic cylinders and lines.
  4. Perform steering, service brake, and parking brake operation checks (per O&MM by machine model).
  5. Check secondary steering operation (if equipped).
  6. Check gauges, indicators, and action light frequently.
Moving the Machine operation
  1. Ensure area is clear.
  2. Raise all lowered implements.
  3. Depress service brake pedal.
  4. Release the parking brake.
  5. Move transmission control lever to desired direction.
  6. Release service brake pedal and depress accelerator pedal.
Starting the Machine operation
  1. Turn the battery disconnect switch to ON (if equipped).
  2. Engage the parking brake.
  3. Adjust seat, adjust mirrors, fasten seat belt.
  4. Move direction control lever into neutral.
  5. Ensure all implements are grounded.
  6. Move the attachment control levers to HOLD.
  7. Ensure all personnel are clear of machine.
  8. Sound horn.
  9. Use ether start aid switch if necessary (per OMM).
  10. Turn key start switch to ON.
  11. Perform startup test or observe monitoring system self-test (if applicable).
  12. Turn key start switch to START. Crank engine.

Extracted from the manufacturer documentation linked to this model. Values are copied as printed; confirm against your unit's manual and serial number.

Repair guides

4

Step-by-step procedures compiled from the Caterpillar service manual for this model.

Parts

2model family
Part #DescriptionQtySystem
763-2400100 amp alternator1Alternator buy
763-245875 amp alternator1Alternator buy

Compiled from this model's family documentation — may include parts for closely-related variants. Confirm the exact part for your serial number. See the full parts catalog to search and cross-reference.

Available documents

Operator's manual — Wheel Loader Start-up and Shut Down Procedure (Caterpillar)Reference — PHB29 (Caterpillar)Owner's manual — Safety+&+Maintenance+Checklist-Wheel+Loaders+V0810.1 (Caterpillar)

This page was generated from the 3 manufacturer documents above by automated extraction; every figure shown is copied from one of them. How the data is compiled.