Doosan DP086TA Engine Engine

• Unit shuts down
  Fix: Check DC supply voltage is not above 35 Volts or below 9 Volts. Check the operating temperature is not above 70°C. Check the DC fuse.
• Unit is inoperative
  Fix: Read/Write configuration does not operate Check the battery and wiring to the unit. Check the DC supply. Check the DC fuse.
• Starter motor inoperative
  Fix: Check wiring to starter solenoid. Check battery supply. Check battery supply is present on the Starter output of module.
• Pre-heat inoperative
  Fix: Check wiring to engine heater plugs. Check battery supply. Check battery supply is present on the Pre-heat output of module. Check pre-heat configuration is correct.
• Generator fails to start on receipt of Remote Start signal
  Fix: Check Start Delay timer has timed out. Check signal is on 'Remote Start' input. Confirm correct configuration of input is configured to be used as 'Remote Start'.
• Fail to Start is activated after pre-set number of attempts to start
  Fix: Check wiring of fuel solenoid. Check fuel. Check battery supply. Check battery supply is present on the Fuel output of the module. Check the speed-sensing signal is present on the module's inputs. Refer to engine manual.
• Continuous starting of generator when in the Auto Mode
  Fix: Check that there is no signal present on the 'Remote Start' input. Check configured polarity is correct. Check the mains supply is available and within configured limits.
• Check that the oil pressure switch or sensor is indicating low oil pressure to the controller
  Fix: Depending upon configuration, then set will not start if oil pressure is not low.

Compiled from service & troubleshooting documentation across every generator set that uses the Doosan DP086TA.