HomeEnginesIsuzu 4LE2TAGV-08

Isuzu 4LE2TAGV-08 Engine Engine

The Isuzu 4LE2TAGV-08 is a 2.18 L engine rated at 1800 rpm, producing up to 36.2 kW. It powers generator sets from Generac, including the MLT4200IV.

Also known as: Isuzu 4LE2TAGV-08

Part of the Isuzu 4LE2TAGV engine family — 2 variants share parts & fitment.

2.18 L
Displacement
1800 rpm
Rated speed
36 kW
Gross power

Engine specifications

Displacement2.18 L
Rated speed1800 rpm
Gross power36 kW

Generator sets powered by this engine

1

Common problems

7
  • Unit starts but stumbles and dies
    Cause: Low ambient temperature, Intake heat inoperable, Air in fuel lines, High coolant temperature shutdown
    Fix: Verify if ambient temperature is within unit limits., Inspect engine air inlet heater function., Purge air from fuel lines., Allow engine to cool. Check coolant level in radiator. Add coolant level if needed., Inspect radiator shroud and ducting for blockage and remove any foreign matter., Inspect for visible leaks. Check tension of water pump drive belt., Contact a GMASD to replace., Remove load on generator and restart engine. Check coolant temperature and shut engine down immediately if it starts to overheat.
  • Unit cranks but does not start
    Cause: Low fuel level, Restricted air filter, Fuel flow obstructed, Air in fuel system, Glow plug(s) inoperable
    Fix: Verify fuel level in tank., Inspect air filter for blockage., Inspect fuel supply hose from tank to fuel filter for cracks and abrasion., Check fuel pump operation., Purge air from fuel system., See the OEM engine manual for more information.
  • One or more lights do not turn on
    Cause: Light breaker tripped.
    Fix: Inspect light breakers.
  • Mast lights off, checking inside control box
    Cause: Loose lighting connections
    Fix: Inspect the connections inside the control box.
  • Loose mast cable connector
    Fix: Verify outside connector is connected properly to inside control box.
  • Lights not turned on
    Cause: Inspect electronic control to see if lights are on. Turn lights on.
    Fix: Turn lights on. If problems continue, contact Generac Mobile at 1-800-926-9768 for assistance.
  • Generator output incorrect
    Fix: Check the incoming voltage to the ballast driver by checking the available voltage on the GFCI receptacle. Incoming voltage should be 120V ± 5V. If voltage is incorrect, the generator may require service.

Compiled from service & troubleshooting documentation across every generator set that uses the Isuzu 4LE2TAGV-08.

Maintenance schedule

ItemSpecCapacityPart #Interval
Air filterInspect and replace air filter element as required. find
Fuel filterReplace fuel filter element as required.69858 Amazon eBay $42.74 PartsGeek
Oil filter670570304500 hr PartsGeek $7.98
BeltInspect and replace fan belt as required. find
Coolant1000 hr
Oil4.7 L500 hr

Pooled from every document that names this exact engine — confirm the interval and part number against your unit's serial number.

Parts cataloged across the Isuzu 4LE2TAGV family

36
Part #DescriptionCategory
90243Air Filter Elementair_filter
003784Lubricant for winch maintenancefluid
00243Greasegrease
00852Home and generator voltage and frequency operator screensoperator_screen
000265Film of grease on the coupler will extend coupler life and eliminate squeaking.other_service
000393aADVERTENCIA: PRODUCE CÁNCER Y DAÑOS REPRODUCTIVOSother_service
000394WARNINGother_service
00131PROPER MAST CABLE ROUTINGother_service
00194Breakers Located Behind The Panelother_service
00204Central Lift Pointother_service
00206Transfer Switch Diagramother_service
00229Water Supply and Mast Lowering Instructionsother_service
002306Trailer Wheel Bearing Grease Zerk Fittingother_service
002327Remote Start Terminal Blockother_service
002329Dusk to Dawn Screenother_service
002354Engine Speed Selection Tableother_service
002355Spark Arresterother_service
002544Alarms screenother_service
002807WHITE Incoming utility power GRAY Normal utility power circuit BLACK Emergency generator power circuitother_service
002832(000278) WARNING Burn hazard. Lamps become extremely hot while in use. Allow 10–15 minutes for cooling before handling or lowering mast. Touching a hot lens or fixture can cause severe burns.other_service
003779Alarms screenother_service
003780Event Log Screenother_service
003781Low Oil Pressureother_service
003782Underspeedother_service
003975other_service
003980High Voltage. Verify area above unit is clear of overhead wires and obstructions. Contact with high-voltage power lines will result in death or serious injury.other_service
003981WARNING Consult Manual. Read and understand manual completely before using product. Failure to completely understand manual and product could result in death or serious injury.other_service
004551Equipment Damage. Failure to perform a daily inspection could result in damage to the unit.other_service
00851Stop/Reset Mode LEDother_service
00886Remote Start Switch Terminalsother_service
00899Turn Lights On or Off Individuallyother_service
00900B31: | 35B25-'| COVER,BEARINGother_service
00908Use Lower Forklift Pockets To Lift Do NOT Use To Liftother_service
209649Form: SFC626Bother_service
003984Remote Start Terminal Blockremote_start_terminal_block
006983Transfer Switchtransfer_switch

Parts cataloged across all variants of this engine family — verify the exact part fits your specific variant and serial number before ordering.

Filters for this engine

  • Air filter: Generac OE3557 Generac OE3656 Isuzu 8972319000 Isuzu 5864014350 Isuzu 8972599390 Donaldson P827653 Donaldson P821575 Donaldson P822858
  • Fuel filter: Generac 69858 Isuzu 8944015310 Isuzu H132401 Donaldson P502166 Donaldson P550057 Wix 33263 Wix 33386 Ac Delco TP1231
  • Oil filter: Generac 670570304 Isuzu 5876100080 Donaldson P550162 Wix 51334 Ac Delco X45

Cross-referenced via Donaldson + OEM/engine-maker interchange — options to verify against your serial number, not confirmed for every exact variant.

Also used in

3
  • Hitachi ZX40U — Excavator Compact
  • Hitachi ZX50U — Excavator Compact
  • Kobelco SK80 — Excavator Tracked

Other equipment known to use this engine, via filter-application cross-reference — useful for sourcing parts even when your exact machine isn't listed elsewhere on this page.

Common questions

What is the displacement of the Isuzu 4LE2TAGV-08?

The Isuzu 4LE2TAGV-08 has a displacement of 2.18 liters.

Which generators use the Isuzu 4LE2TAGV-08 engine?

The Isuzu 4LE2TAGV-08 powers 1 generator set(s), including Generac MLT4200IV.

What oil filter does the Isuzu 4LE2TAGV-08 use?

The Isuzu 4LE2TAGV-08 uses oil filter part numbers Generac 670570304, Isuzu 5876100080, Donaldson P550162.

What fuel filter does the Isuzu 4LE2TAGV-08 use?

The Isuzu 4LE2TAGV-08 uses fuel filter part numbers Generac 69858, Isuzu 8944015310, Isuzu H132401.

What air filter does the Isuzu 4LE2TAGV-08 use?

The Isuzu 4LE2TAGV-08 uses air filter part numbers Generac OE3557, Generac OE3656, Isuzu 8972319000.

How often should you change the oil in the Isuzu 4LE2TAGV-08?

The Isuzu 4LE2TAGV-08 oil change interval is every 500 hours.

What is a common problem with the Isuzu 4LE2TAGV-08 engine?

A commonly reported issue on generators using the Isuzu 4LE2TAGV-08 is: Unit starts but stumbles and dies. Cause: Low ambient temperature, Intake heat inoperable, Air in fuel lines, High coolant temperature shutdown. Fix: Verify if ambient temperature is within unit limits., Inspect engine air inlet heater function., Purge air from fuel lines., Allow engine to cool. Check coolant level in radiator. Add coolant level if needed., Inspect radiator shroud and ducting for blockage and remove any foreign matter., Inspect for visible leaks. Check tension of water pump drive belt., Contact a GMASD to replace., Remove load on generator and restart engine. Check coolant temperature and shut engine down immediately if it starts to overheat..