Wisconsin — Set float level
Adjustments · Zenith 87 carburetor
From a Wisconsin manual covering: HS7D, HS8D, MVH4D, S10, S10D0, S12D, S12D0, S12D2, S14D, S14D2, S7D, S8D…. Check it applies to your exact model before use.
Browse Wisconsin generators & specs →
Procedure
- Hold bowl cover inverted with mounting flange to operator's right
- Measure from machined surface no gasket to top side of float body
- Setting should be 61/64 in plus or minus 1/32 in
- Bend float lever close to float body with long nosed pliers if needed
- Replace float if off more than 1/16 in
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 61/64 in ± 1/32 in
Source: Wisconsin manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.