Winco — Initial Start Up / Basic Operation
Operation · engine
From a Winco service manual covering: WL12000HE-03/A, WL12000HE-03/B, WL12000HE-03/C, WL12000HE-03/D. Check it applies to your exact model before use.
Browse Winco generators & specs →
Before you start
- Unit will not start if low on oil
Procedure
- Check oil level, refill as needed
- Turn on the fuel supply
- Engage the choke by pulling it out
- Turn the engine switch to the ON position
- Rotate the key switch briefly to START; do not operate starter more than 5 seconds, wait at least 10 seconds between cycles
- When engine starts, release the key switch to return to ON
- Gradually push the choke in as the engine warms up
- Allow engine to come up to operating speed
Specs & values
- Throttle preset/locked at 3600 RPM nominal, no-load speed 3690 RPM
Source: Winco service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.