Winco HPS9000VE-03/A — Stopping and Storing

Maintenance · whole unit

For the Winco HPS9000VE-03/A, from the Winco service manual.

Browse Winco generators & specs →

Procedure

1. Move the key to the OFF position
2. Turn off the fuel supply valve
3. Add fuel stabilizer to the fuel in the tank and run for 2 minutes to circulate
4. Drain remaining fuel into approved container if desired
5. Start the engine and run until fuel in carburetor and lines is used up
6. While engine is warm, drain the oil and refill with fresh oil
7. Clean dirt and chaff from cylinder, cylinder head fins, blower housing, screen, muffler areas
8. Store in a clean and dry area

Source: Winco service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Winco repair guides →