Winco HPS9000VE-03/A — Changing Fuel Types: Gasoline to LP/NG

Operation · fuel system

For the Winco HPS9000VE-03/A, from the Winco service manual.

Browse Winco generators & specs →

Procedure

1. With engine running, turn off the gasoline valve
2. Run the engine until it runs out of fuel
3. Remove the plastic insert from the demand regulator
4. Install a locally approved flexible fuel line
5. Connect the LP/NG fuel line to the flexible fuel line
6. Ensure hose is attached to proper fitting (LP or NG)
7. Turn on the vapor fuel
8. Start the engine
9. Apply the load to the generator

Source: Winco service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Winco repair guides →