Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Westinghouse›Starting the Generator - Manual Start

Westinghouse WH5500 — Starting the Generator - Manual Start

Operation · Engine

For the Westinghouse WH5500, from the Westinghouse owner's manual.

Browse Westinghouse generators & specs →

Before you start

  • Ensure all loads are disconnected before starting

Procedure

  1. Make sure circuit breakers are properly set.
  2. Move fuel shutoff valve to ON position.
  3. Move choke lever to ON position.
  4. Push engine control switch into RUN position.
  5. Firmly grasp and pull recoil handle slowly until increased resistance felt.
  6. Apply rapid pull while pulling up and slightly away from generator.
  7. As engine starts and stabilizes, gradually move choke lever to OFF position.

Source: Westinghouse owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Westinghouse repair guides →