Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›When the motor is cut in, a gear on the armature shaft

Volvo Group 23 EDC III — When the motor is cut in, a gear on the armature shaft

For the Volvo Group 23 EDC III.

Browse Volvo generators & specs →

Procedure

  1. 1. Coolant level monitor
  2. 2. Tachometer sensor, camshaft
  3. 3. Connection, diagnostic tool*
  4. 4. Programming plug*
  5. 5. Charge air pressure/temperature sensor
  6. 6. Extra stop
  7. 7. Main relay*
  8. 8. Generator
  9. 9. Fuse 10A
  10. 10. Oil pressure/temperature sensor
  11. 11. Control unit (ECU)
  12. 12. Fuel pressure monitor
  13. 13. 8–pin connection (Data bus)
  14. 14. 23–pin connection (Stand alone)

Source: manual:Workshop Manual 12liter EDCIII.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.