HDT — Adjustment with Optional Accessory Board

For the HDT.

Procedure

1. 4. Verify that the generator set engine starts and the
2. GEN Available LED flashes.
3. 5. For a loaded test, the switch transfers the load to
4. the emergency source (generator set) after the
5. transfer to Emergency time delay. Verify that the
6. Utility Source Position LED goes out and the GEN
7. Position LED lights.
8. 6. Press and hold the Test button for 2 seconds to end
9. the test.
10. 7. For a loaded test, the switch transfers the load to
11. the normal (utility) source.
12. Verify that the GEN

Source: manual:MP6346.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.