Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Note: Field adjustment can only be considered approximate if potentiometers are set us-

Transfer Switches - LakeShore — Note: Field adjustment can only be considered approximate if potentiometers are set us-

A Transfer Switches - LakeShore service procedure — check it applies to your exact model before use.

Browse Transfer Switches - LakeShore generators & specs →

Procedure

  1. 1. Remove protective black plugs.
  2. 2. Using a small slotted screwdriver, turn the dropout potentiometer fully
  3. 3. Using a small slotted screwdriver, turn the pickup potentiometer fully clock-
  4. 4. Apply required level of pickup voltage to the unit.
  5. 5. Turn the pickup potentiometer slowly counter-clockwise until the meter
  6. 6. Reduce the voltage to the required voltage dropout level.
  7. 7. Turn the dropout potentiometer slowly clockwise until the meter shows no
  8. 8. PROGRAM TIME CLOCK
  9. 1. To remove unit from enclosure: Push tab on right to swing unit to the left and remove.
  10. 2. Mount the enclosure at eye level using screws or other suitable fastening device. Bring
  11. 3. Install 9 volt alkaline battery (not supplied) by sliding battery cover in direction of arrow
  12. 4. Reinstall unit by reversing step #1 above and connect wires to unit as per suggested wir-
  13. 1. Press MODE key until display shows CLK.
  14. 2. Press DAY key to select current day. Press HOUR key to select current hour. Check A
  15. 1. If display does not show SCH, press mode key until display shows SCH.
  16. 2. Press HOUR and MIN keys for the first ON setting (check for AM or PM).
  17. 3. Press ENTER key to store the information and display will indicate it is ready to receive
  18. 4. Press HOUR and MIN keys for the first OFF setting. Then press ENTER key to store the
  19. 5. Proceed for up to 7 ON and 7 OFF setpoints. Then press MODE key and unit will go to the
  20. 1. Press mode key until display shows SKIP. Press DAY key and M (Monday) starts flashing.

Source: manual:Styles 2, 3 and T-200 New Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.