Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›2. Mount the enclosure at eye level using screws or other suitable fastening device. Bring

Transfer Switches - LakeShore — 2. Mount the enclosure at eye level using screws or other suitable fastening device. Bring

A Transfer Switches - LakeShore service procedure — check it applies to your exact model before use.

Browse Transfer Switches - LakeShore generators & specs →

Procedure

  1. 3. Install 9 volt alkaline battery (not supplied) by sliding battery cover in direction of arrow
  2. 4. Reinstall unit by reversing step #1 above and connect wires to unit as per suggested wir-
  3. 1. Press MODE key until display shows CLK.
  4. 2. Press DAY key to select current day. Press HOUR key to select current hour. Check A
  5. 1. If display does not show SCH, press mode key until display shows SCH.
  6. 2. Press HOUR and MIN keys for the first ON setting (check for AM or PM).
  7. 3. Press ENTER key to store the information and display will indicate it is ready to receive
  8. 4. Press HOUR and MIN keys for the first OFF setting. Then press ENTER key to store the
  9. 5. Proceed for up to 7 ON and 7 OFF setpoints. Then press MODE key and unit will go to the
  10. 1. Press mode key until display shows SKIP. Press DAY key and M (Monday) starts flashing.
  11. 1. CLOCK - ALTER TIME
  12. 2. SCHEDULE - REVIEW
  13. 3. SCHEDULE - MODIFY
  14. 4. SKIP DAYS - ADD/DELETE
  15. 9. TROUBLESHOOTING GUIDE
  16. 1. A wiring diagram for the switch must be available.
  17. 2. Normal and Emergency voltage and frequency must be available and within the
  18. 3. Control circuit voltage (if transformers are used) must be 110 to 125 volts.
  19. 4. Connections to the PFR must be correct and the relay must be adjusted to pick up
  20. 5. All timers must be turned down or consideration given to them while the tests are

Source: manual:Styles 2, 3 and T-200 New Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.