Transfer Switches - Eaton Cutler Hammer ATC-300 — Style number of ATS, if applicable;

For the Transfer Switches - Eaton Cutler Hammer ATC-300.

Applies to: Transfer Switches Eaton Cutler Hammer Atc 300

Procedure

1. Style number of ATS, if applicable;
2. Catalog number of ATS;
3. Actual location of the ATS (type of facility, address, etc.);
4. Company name and name and position of individual repre­ senting company;
5. Basic description of the situation as it exists; and
6. Any results of the problem solving steps taken and/or read­ ings taken. NOTICE AT THIS POINT, AND PRIOR TO MAKING ANY ATTEMPT TO ENER­ GIZE THE ATS EQUIPMENT, THE ENGINE-DRIVEN GENERATOR SHOULD BE OPERATED. IF NECESSARY, THE VOLTAGE REGULA­ TOR ON THE GENERATOR SHOULD BE ADJUSTED ACCORDING TO THE MANUFACTURER’S RECOMMENDATIONS. THE ATS EQUIP­ MENT WILL RESPOND ONLY TO THE RATED VOLTAGE AND FRE­ QUENCY PROGRAMMED INTO THE CONTROLLER. WARNING DO NOT ATTEMPT TO MANUALLY OPERATE THE ATS WITH THE SOURCE 1 POWER SOURCE CONNECTED AND AVAILABLE. DO NOT ATTEMPT TO MANUALLY OPERATE THE ATS WITH THE SOURCE 2 POWER SOURCE CONNECTED AND AVAILABLE. WARNING HAZARDOUS VOLTAGES IN AND AROUND ATS EQUIPMENT DUR­ ING THE PROBLEM SOLVING PROCESS CAN CAUSE SEVERE PER­ SONAL INJURY AND/OR DEATH. AVOID CONTACT WITH ANY VOLTAGE SOURCE WHILE PROBLEM SOLVING. WARNING ONLY PROPERLY TRAINED PERSONNEL, FAMILIAR WITH THE ATS EQUIPMENT AND ITS ASSOCIATED EQUIPMENT, SHOULD BE PER­ MITTED TO PERFORM THE PROBLEM SOLVING FUNCTION. IF AN INDIVIDUAL IS NOT QUALIFIED TO PERFORM THE PROBLEM SOLV­ ING FUNCTION, THE INDIVIDUAL SHOULD NOT ATTEMPT ANY OF THESE PROCEDURES. IB01602015E For more information visit: www.eaton.com Instruction Booklet Effective: August 2010 Page 23 ATC-300 2-Postion Contactor  Based Transfer Switch Section 7: Adjustments

Source: manual:ATC 300 2 pos Contactor ATS Instruction manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.