Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Replace defective components after the

Transfer Switches - Eaton Cutler Hammer — Replace defective components after the

For these Transfer Switches - Eaton Cutler Hammer models: IB ATS-G001, IB ATS-GO01.

Browse Transfer Switches - Eaton Cutler Hammer generators & specs →

Procedure

  1. Step 5: Manually ratchet the operating handle to the
  2. 6-2.2 MOTOR KEEPS TURNING AND TRANSFER
  3. Step 1: Check the appropriate limit switch (NLS or ELS).
  4. 6-2.3 TRANSFER SWITCH WILL NOT
  5. Step 1: Are the correct line voltage and frequency
  6. Step 2: Is the voltage selector plug in the
  7. Step 3: Is the TEST SWITCH in the TEST position?
  8. Step 4. Check the voltage on microprocessor logic
  9. 120 VAC +10 volts.

Source: manual:CUTLER HAMMER Westinghouse ATS 150_1000 Instructional Manual 1995.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.