Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Blade Screwdriver Removal and Installation

Transfer Switches - Eaton Cutler Hammer — Blade Screwdriver Removal and Installation

A Transfer Switches - Eaton Cutler Hammer service procedure — check it applies to your exact model before use.

Browse Transfer Switches - Eaton Cutler Hammer generators & specs →

Procedure

  1. 1. Turn the utility (Source 1) power off and turn the generator (Source 2) control selector switch.
  2. 2. If necessary, insert a blade screwdriver up through the circular hole in the load lug bus.

Tools required

  • Blade screwdriver

Source: manual:CHGEN ATS.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.