Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Initiate a Load

Transfer Switches - Eaton Cutler Hammer — Initiate a Load

A Transfer Switches - Eaton Cutler Hammer service procedure — check it applies to your exact model before use.

Browse Transfer Switches - Eaton Cutler Hammer generators & specs →

Procedure

  1. This should be done by opening the upstream breaker
  2. The generator should start and the ATS should trans-
  3. After transfer, close the upstream breaker, or close

Source: manual:ATC-100 manual Contactor Based IB01602017E rev2009.PDF. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.