Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›4.7 Mounting the Switching Device in the Drawout

Transfer Switches - Eaton Cutler Hammer — 4.7 Mounting the Switching Device in the Drawout

A Transfer Switches - Eaton Cutler Hammer service procedure — check it applies to your exact model before use.

Browse Transfer Switches - Eaton Cutler Hammer generators & specs →

Procedure

  1. 4.8 Wiring
  2. 4.8.1 Engine Start Connection
  3. 4.8.2 ALARM CONTACTS (CLOSED TRANSITION ONLY)
  4. 5.1 General
  5. 25. An indicator window shows whether the switch is open or
  6. 3.2.2). An indicator window shows whether the switch is open
  7. 5.2 Automatic Transfer Switch
  8. 2. Open both switching devices
  9. 4. Verify source availability
  10. 5. Close switching device on available
  11. 1. Disconnect Logic Connectors
  12. 3. Verify "OPEN" flags
  13. 6.1 Installing a Drawout Switching Device
  14. 6.1.1 Switching Device Positioning
  15. 6.1.2 Levering the Switching Device
  16. 6.2. Fixed Switching Device
  17. 6.3 Switching Device Operation
  18. 7.1 Operator Panel
  19. 7.2 Automatic Operation

Source: manual:Magnum ATS Instructions.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.