Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›4.6 Voltage Selection Adjustment

Transfer Switches - Eaton Cutler Hammer — 4.6 Voltage Selection Adjustment

A Transfer Switches - Eaton Cutler Hammer service procedure — check it applies to your exact model before use.

Browse Transfer Switches - Eaton Cutler Hammer generators & specs →

Procedure

  1. 4.7 Mounting the Switching Device in the Drawout
  2. 4.8 Wiring
  3. 4.8.1 Engine Start Connection
  4. 4.8.2 ALARM CONTACTS (CLOSED TRANSITION ONLY)
  5. 5.1 General
  6. 25. An indicator window shows whether the switch is open or
  7. 3.2.2). An indicator window shows whether the switch is open
  8. 5.2 Automatic Transfer Switch
  9. 2. Open both switching devices
  10. 4. Verify source availability
  11. 5. Close switching device on available
  12. 1. Disconnect Logic Connectors
  13. 3. Verify "OPEN" flags
  14. 6.1 Installing a Drawout Switching Device
  15. 6.1.1 Switching Device Positioning
  16. 6.1.2 Levering the Switching Device
  17. 6.2. Fixed Switching Device
  18. 6.3 Switching Device Operation
  19. 7.1 Operator Panel
  20. 7.2 Automatic Operation

Source: manual:Magnum ATS Instructions.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.