Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›4.4 Mounting Procedure

Transfer Switches - Eaton Cutler Hammer — 4.4 Mounting Procedure

A Transfer Switches - Eaton Cutler Hammer service procedure — check it applies to your exact model before use.

Browse Transfer Switches - Eaton Cutler Hammer generators & specs →

Procedure

  1. Step 1: Mounting and cabling access is best provided by remov- ing side and rear covers (when applicable). See Section
  2. 9.3 for cover removal instructions.
  3. Step 2: Gently maneuver the switch into its location using all of the supplied lift brackets.
  4. Step 3: Bolt the enclosure to the base. Use separate cleats (Option 42 only) if Seismic Uniform Building Code (UBC)

Source: manual:Magnum ATS Instructions.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.