Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Plunger Removal and Rectifier Replacement

SBL/SCL — Plunger Removal and Rectifier Replacement

For the SBL/SCL.

Procedure

  1. Use 1/4 inch open-end wrench on plunger flats.
  2. Turn plunger counterclockwise to remove from swing bolt.
  3. Install new rectifier.
  4. Connect rectifier AC connections to wiring harness.
  5. If replacing plunger, install new plunger on swing bolt to same length as removed.

Tools required

  • 1/4 inch open-end wrench

Source: manual:mp5668.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.