Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Tools Required

PSI (Power Solutions Intl) — Tools Required

A PSI (Power Solutions Intl) service procedure — check it applies to your exact model before use.

Browse PSI (Power Solutions Intl) generators & specs →

Procedure

  1. 1. Remove the camshaft rear bearing hole plug.
  2. 2. Use the J 6098-01 in order to remove the inner camshaft
  3. bearings. Repeat the following procedure for each of the
  4. inner camshaft bearings:
  5. 2.1. With the nut (4) and the thrust washer (3) installed
  6. to the end of the puller screw threads, index the
  7. pilot (2) in the camshaft front bearing and install the
  8. puller screw through the pilot (2) and the bearing to
  9. be removed.
  10. 2.2. Install the bearing tool (1) with the shoulder toward
  11. the bearing.
  12. 2.3. Using two wrenches, hold puller screw (5) while you
  13. turn the nut (4) in order to draw the bearing out of
  14. the bore.
  15. 2.4. When the bearing has been pulled from the bore,
  16. remove the bearing tool and the bearing from the
  17. puller screw.
  18. 2.5. Index the pilot in the rear camshaft bearing in order
  19. to remove the rear inner camshaft bearing.
  20. 3.0L ENGINE SERVICE MANUAL
  21. 41
  22. VE056-3L
  23. VE057-3L
  24. Distributor Lower Bushing and Thrust Washer
  25. Removal
  26. Tools Required
  27. • J 9534 Distributor Lower Bushing Remover
  28. • J 6585 Slide Hammer
  29. 1. Install the J 9534 into the distributor lower bushing.
  30. 2. Use the J 6585 in order to remove the bushing.
  31. 3. Use a drift punch up through the bushing bore in order to
  32. drive the thrust washer (if installed) out of the bore.
  33. 4. Clean the bushing bore in the cylinder block and inspect
  34. for burrs or damage.
  35. VE058-3L
  36. Oil Filter Bypass Valve Removal and Installation
  37. 1. Check the spring and fiber valve for operation.
  38. 2. Inspect for a cracked or broken valve.
  39. 3. Use a screwdriver in order to pry the valve out.
  40. 4. Use a 9/16 in thin-wall deep socket in order to tap the
  41. new bypass valve in place.

Source: manual:3.0L-Engine-Service-Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.