Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Replace Ignition Coils and Boots

PSI (Power Solutions Intl) 32L — Replace Ignition Coils and Boots

For the PSI (Power Solutions Intl) 32L.

Browse PSI (Power Solutions Intl) generators & specs →

Procedure

  1. Remove all ignition coils and boots. Save all hardware.
  2. Apply a pea-sized amount of Super Lube dielectric grease at the spring.
  3. Apply additional thin layer around the interior of the coil boot to lubricate contact with the spark plug.
  4. Install new boots and coils on the engine using the existing hardware.

Specs & torque values

  • Super Lube dielectric grease

Source: manual:56100024-12-32L-Operations-Maintenance-Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.