Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Disassembling Steps of Gear Chamber

PSI (Power Solutions Intl) 10L Turbo — Disassembling Steps of Gear Chamber

For the PSI (Power Solutions Intl) 10L Turbo.

Browse PSI (Power Solutions Intl) generators & specs →

Before you start

  • Symmetrically and crosswise tighten up the gear chamber fastening bolts in the specified order.
  • Before assembly of the seal ring, observe if there is scratch or other defects on the seal ring
  • if there is, timely replace it. For assembling, apply oil onto the seal ring, completely press it into groove, and avoid scratching the seal ring by groove.
  • For disassembling the gear chamber, first dismantle the gear chamber fastening bolts, and then disassemble the intermediate gear shaft and oil pump intermediate gear shaft. After disassembly of gear chamber, put it in a clean environment.

Procedure

  1. Disassemble the gear chamber fastening bolt
  2. Disassemble the screw plug and composite washer;
  3. Disassemble the gear chamber
  4. Disassemble the seal ring

Tools required

  • Socket wrench

Specs & torque values

  • Gear chamber fastening bolt tightening torque: 44-58 N·m

Source: manual:10L-10LT-Engine-Service-Manual-7610035-2.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.