PSI (Power Solutions Intl) — 2) Remove fixing bolts

A PSI (Power Solutions Intl) service procedure — check it applies to your exact model before use.

Browse PSI (Power Solutions Intl) generators & specs →

Procedure

1. 3) Remove oil pan
2. 4) Remove plugs and connectors
3. 2.8.3. Steps to assemble oil pan
4. Reverse disassembly procedure to assemble oil pan.
5. 2.8.4. Oil pan inspection and repair
6. Key point 1
7. Before the disassembling, all engine oil should be drained out. Put an engine oil container
8. under drain screw plug of oil sump, screw off the plug with a plug wrench to drain oil out.
9. Key point 2:
10. Assembling
11. 1) Apply sealant on fitting surface of engine block and partially apply sealant on oil
12. sump, place sealing gasket on the fitting surface.
13. 2) Lift and place oil sump, be careful and avoid crashing the fitting surface.
14. 3) Install bolts and gaskets and tighten the bolts with pneumatic impact wrench to 20~35.5Nm.
15. 33
16. 2.9 Cylinder head assembly and disassembly
17. 2.9.1. Exploded view of cylinder head
18. Figure 17
19. 2.9.2. Steps to disassemble cylinder head
20. 1) Loosen the cylinder head bolts and remove them.
21. 2) Pull the cylinder head up vertically to take it down. If the cylinder head gasket is attached
22. on the removed cylinder head, remove it and place it back on engine block. Put the
23. removed cylinder head on cardboard to prevent damage to the upper surface of the
24. combustion chamber and other sealing surfaces. If more than one cylinder head needs to
25. be disassembled, mark the cylinder number on the head for reference.

Source: manual:4.5L-Engine-Service-Manual-7610033-2.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.