PSI (Power Solutions Intl) — Camshaft Bearing Removal

A PSI (Power Solutions Intl) service procedure — check it applies to your exact model before use.

Browse PSI (Power Solutions Intl) generators & specs →

Procedure

1. Remove the camshaft rear bearing hole plug.
2. Use the J 6098-01 to remove the inner camshaft bearings. Repeat for each bearing:
3. With the nut (4) and thrust washer (3) installed to end of puller screw threads, index the pilot (2) in the camshaft front bearing
4. Install the bearing tool (1) with the shoulder toward the bearing.
5. Using two wrenches, hold puller screw (5) while turning the nut (4) to draw the bearing out of the bore.
6. When bearing is removed, remove the bearing tool and bearing from the puller screw.
7. Index the pilot in the rear camshaft bearing to remove the rear inner camshaft bearing.

Source: manual:3.0L-Engine-Service-Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.