Power Solutions International — Replace Ignition Coils and Boots
Maintenance
From a Power Solutions International owner's manual — check it applies to your exact model before use.
Browse Power Solutions International generators & specs →
Procedure
- Remove all ignition coils and boots; save all hardware.
- Apply a pea-sized amount of Super Lube dielectric grease at the spring.
- Apply a thin layer around the interior of the coil boot.
- Install new boots and coils using the existing hardware.
Tools required
- Super Lube dielectric grease Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Power Solutions International owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.