Power Solutions International 560001-R2 — Oil Pan Installation
Repair & overhaul
For the Power Solutions International 560001-R2, from the Power Solutions International service manual.
Browse Power Solutions International generators & specs →
Procedure
- Remove any and all debris from below the engine block.
- Apply HZ-1213 silicone sealant to the oil pan gasket and crank end cover.
- Install oil pan and torque bolts to 7-9 Nm in sequence (1-18).
- Torque the three crank end cover bolts to 7 Nm.
- Cut off any sealant extruding from the oil pan and crank end cover.
- Torque the oil drain plug to 4 Nm.
Tools required
- Sealant HZ-1213 Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Oil pan bolts 7-9 Nm (sequence 1-18)
- Crank end cover bolts 7 Nm
- Oil drain plug 4 Nm
Source: Power Solutions International service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.