Perkins — Viewing or Changing the Settings of the Monitoring System
Testing & diagnosis · Engine monitoring system
From a Perkins service manual — check it applies to your exact model before use.
Browse Perkins generators & specs →
Before you start
- Changing the parameters during engine operation can cause the engine to operate erratically and can cause engine damage. Only change the settings of the parameters when the engine is STOPPED.
Procedure
- Select the Service/Monitoring System screen on the electronic service tool. Ensure that the correct ECM is selected.
- Highlight the desired parameter. Then click the Change button in the lower left corner of the screen.
- Change the State of the parameter.
- Set the Trip Point and the Delay Time according to the Allowed Values displayed in the lower half of the screen.
- Click the OK button. If a password is required, the Enter Passwords screen will appear; enter the correct passwords and click the OK button.
Tools required
- Electronic service tool Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.