Perkins — To Replace Engine Starter
Repair & overhaul
From a Perkins service manual — check it applies to your exact model before use.
Browse Perkins generators & specs →
Before you start
- Always disconnect battery cables before working on or near electrical components
Procedure
- Open the engine cover and side door.
- Disconnect battery cables from machine.
- Remove the air cleaner assembly from the engine.
- Reach over the top of the engine and locate the starter.
- Remove the wires attached to the starter; label them.
- Remove the three M10 hex screws holding the starter to the bellhousing; remove starter.
- Reverse steps to reinstall a new or rebuilt starter.
- Reinstall the air cleaner to the engine.
- Reconnect the battery and start the machine; check starter operation.
Specs & values
- M10 hex screws 37--48 Nm (26--34 ft lb)
Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.