Perkins — Seat Assembly Installation

A Perkins service procedure — check it applies to your exact model before use.

Browse Perkins generators & specs →

Procedure

1. Position the seat assembly back on the machine.
2. Install the two sleeves, washers, and M8 hex bolts. Hand tighten.
3. Tilt the seat assembly forward and hold it in this position.
4. Reinstall the seat prop rod to the bottom of the seat using the M6 hex screw, nyloc nut, and washers. Hand tighten until snug.
5. Lower the seat.

Source: manual:tennant-800-810-rider-floor-sweeper-service-manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.