Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Removal Procedure

Perkins — Removal Procedure

A Perkins service procedure — check it applies to your exact model before use.

Browse Perkins generators & specs →

Procedure

  1. 1. Loosen the hose clamps and disconnect air hose
  2. 2. Slide the locking tab into the unlocked position
  3. 3. Slide the locking tab into the unlocked position
  4. 4. Loosen clamp (5) and remove connection (2) from
  5. 5. Remove O-ring seal (9) from inlet manifold (7).
  6. 6. Remove fasteners (8). Note the position of the
  7. 7. Remove inlet manifold (7) from the cylinder head.
  8. 8. Remove gasket (10) (not shown).
  9. 9. If necessary, remove inlet manifold pressure

Source: manual:Disassembly and Assembly-SM-PERKINS 2200 SERIES 2206-E13 INDUSTRIAL ENGINE.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.