Perkins — How to renew the lubricating oil filters
Maintenance
From a Perkins owner's manual covering: 4000 Series, 4006-23 TAG1A, 4006-23 TAG2A, 4006-23 TAG3A. Check it applies to your exact model before use.
Applies to: Perkins 4006-23 TAG1A, Perkins 4006-23 TAG2A, Perkins 4006-23 TAG3A
Before you start
- Discard the used lubricating oil filters in a safe place and in accordance with local regulations.
Procedure
- Put a suitable container below the lubricating oil filter.
- Remove the filter canister (A3) with a suitable strap wrench; discard the canister.
- Clean the filter head (A1).
- Lubricate the top of the canister seal (A2) with clean engine lubricating oil.
- Fit the new canister and tighten it by hand only; do not use a strap wrench.
- Remove the container and discard the old lubricating oil.
- With the starter motor disengaged, check the oil level on the dipstick and add more oil if necessary.
- Run the engine off load and check for oil leaks from the oil system.
Tools required
- Strap wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Each oil filter holds approximately 5 litres (1 gal) of lubricating oil
Source: Perkins owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.