Perkins — Fuel Injector Cover - Remove and Install
Maintenance
From a Perkins service manual — check it applies to your exact model before use.
Browse Perkins generators & specs →
Before you start
- Keep all parts clean from contaminants.
Procedure
- Thoroughly clean all outer surfaces of cover (1) for the fuel injectors.
- Remove setscrews (2) from cover (1).
- Remove cover (1).
- Thoroughly clean all inner surfaces of cover (1).
- Install cover (1).
- Install setscrews (2) for cover (1). Tighten to 9 N·m (7 lb ft).
Specs & values
- 9 N·m (7 lb ft)
Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.