Perkins — Fuel Injection Pump - Remove and Install

A Perkins service procedure — check it applies to your exact model before use.

Browse Perkins generators & specs →

Procedure

1. 1. Ensure that bore in front housing is not damaged as the fuel injection pump is removed.
2. 2. Install plastic tube assemblies.
3. 3. Tighten banjo bolts at the transfer pump end to a torque of 21 N·m (15 lb ft).
4. 4. Install plastic tube assembly.

Source: manual:1106D Disassembly and Assembly.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.