Perkins — Fuel Filter Base - Remove
Repair & overhaul
From a Perkins service manual — check it applies to your exact model before use.
Browse Perkins generators & specs →
Before you start
- NOTICE: Keep all parts clean from contaminants.
Procedure
- Turn fuel supply to OFF.
- Place container below fuel filter base.
- Disconnect harness assembly (4) from fuel pressure sensor (3) and fuel temperature sensor (7).
- Disconnect hose assemblies (5) and (6). Remove O-ring seals.
- Remove secondary fuel filter (11) and O-ring seal.
- Remove bolts (1) and washers (2); remove fuel filter base (10).
- If necessary, remove bracket (12) from cylinder block: remove bolts (14) and washers (13).
Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.