Perkins — Fuel Filter Base - Install (Option 2)
Repair & overhaul
From a Perkins service manual — check it applies to your exact model before use.
Browse Perkins generators & specs →
Before you start
- NOTICE: Keep all parts clean from contaminants.
Procedure
- Ensure all components are free from wear or damage.
- If necessary, position bracket (12) to cylinder block; install washers (10) to bolts (9); install bracket (11); torque to 55 N·m (41 lb ft).
- If necessary, install primary fuel filter assembly.
- Position fuel filter base (7); install washers (2) and bolts (1); tighten to 28 N·m (21 lb ft).
- Install new O-ring seal to secondary fuel filter (8); install filter.
- Connect hose assembly (6).
- Connect tube assembly (3).
- Connect engine harness to fuel pressure sensor (5).
- Secure fuel pressure sensor (5) with new cable strap (4).
- Turn fuel supply to ON.
Specs & values
- 55 N·m (41 lb ft)
- 28 N·m (21 lb ft)
Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.