Perkins — Procedure 8

A Perkins service procedure — check it applies to your exact model before use.

Browse Perkins generators & specs →

Procedure

1. 4. Loosen the locking screw (6). Move the spacer
2. (5) in order to allow the locking screw (6) to
3. tighten against the shaft of the fuel injection
4. pump. Rotate the fuel injection pump gear in a
5. counterclockwise direction in order to remove
6. the backlash. Tighten the locking screw (6) to a
7. torque of 31 N·m (23 lb ft).
8. Note: The locking screw (6) must be tightened in
9. order to prevent the shaft of the fuel injection pump
10. from rotating. The shaft of the fuel injection pump
11. must not be rotated after the fuel injection pump
12. has been removed from the engine.
13. g01011474
14. Illustration 16
15. 5. Remove the nut (7) and the washer from the

Source: manual:Perkins-1103-1104-Series-Workshop-Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.