Perkins — Procedure 3

A Perkins service procedure — check it applies to your exact model before use.

Browse Perkins generators & specs →

Procedure

1. 1. Inspect the fuel injection lines (1) for wear and for
2. damage. Replace any fuel injection line (1) that
3. is worn or any fuel injection line that is damaged.
4. 2. Loosely install the clamps for the fuel injection
5. lines (1).
6. 3. Remove the dust caps from the fuel injection
7. pump (3) and from the fuel injectors (2). Remove
8. the dust caps from the fuel injection lines (1).
9. 4. Loosely connect the nuts at both ends of the fuel
10. injection lines (1).
11. 5. Ensure that each fuel injection line (1) does not
12. contact any other fuel injection line or any other
13. engine component. Tighten the fasteners for the
14. clamps for the fuel injection lines (1). Check that
15. the fuel injection lines (1) are still clear of other

Source: manual:Perkins-1103-1104-Series-Workshop-Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.