Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Disassembly and Assembly Section

Perkins — Disassembly and Assembly Section

A Perkins service procedure — check it applies to your exact model before use.

Browse Perkins generators & specs →

Before you start

  • Note: The removal procedure is identical for the
  • Note: The installation procedure is identical for the

Procedure

  1. 8. Remove the air from the fuel system. Refer to
  2. the Operations and Maintenance Manual, “Fuel
  3. System - Prime”.
  4. End By:
  5. a. Install the cover for the fuel injectors. Refer to
  6. this Disassembly and Assembly Manual, “Fuel
  7. Injector Cover - Remove and Install”.
  8. i01940979
  9. Fuel Injector Cover - Remove
  10. and Install
  11. Removal Procedure
  12. NOTICE
  13. Keep all parts clean from contaminants.
  14. Contaminants may cause rapid wear and shortened
  15. component life.
  16. Note: The removal procedure is identical for the
  17. four cylinder and the three cylinder engines. The
  18. illustration shows the four cylinder engine.
  19. g01011111
  20. Illustration 9

Specs & torque values

  • 9 N·m

Source: manual:Perkins-1103-1104-Series-Workshop-Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.