Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›SEBU8605-01 15 Safety Section Before Starting Engine

Perkins — SEBU8605-01 15 Safety Section Before Starting Engine

A Perkins service procedure — check it applies to your exact model before use.

Browse Perkins generators & specs →

Before you start

  • warning tag is attached to the engine start switch,
  • warning tag before the engine is started.
  • Note: The engine is equipped with a device for cold starting. If the engine will be operated in very cold conditions, then an extra cold starting aid may be required. Normally, the engine will be equipped with
  • dangerous
  • Warning • Derate

Procedure

  1. Do not attach any other item to the high-pressure fuel lines.
  2. Loosened high-pressure fuel lines must be replaced. Also removed high-pressure fuel lines must be replaced. Refer to Disassembly and
  3. Install”. i02813489
  4. tors use DC voltage. The ECM sends this voltage to the electronic unit injectors. Do not come in contact with the harness connector for the elec- tronic unit injectors while the engine is operating.
  5. Warning
  6. Derate
  7. Shutdown
  8. Engine Coolant Temperature
  9. Engine Oil Pressure
  10. Engine Speed
  11. Intake Manifold Air Temperature
  12. Engine Intake Throttle Valve Fault
  13. Wastegate Regulator
  14. Supply Voltage to Sensors
  15. Fuel Pressure in Manifold (Rail)
  16. NOx Reduction System
  17. Engine Aftertreatment System

Tools required

  • gauge

Source: manual:992774__24_1204e_e44t__4tta_mk_ml.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.