Perkins — NOTICE

A Perkins service procedure — check it applies to your exact model before use.

Browse Perkins generators & specs →

Procedure

1. 2. Remove the setscrews (2) from the cover (1).
2. 3. Remove the cover (1).
3. Installation Procedure
4. NOTICE
5. Keep all parts clean from contaminants.
6. Contaminants may cause rapid wear and shortened
7. component life.
8. Note: The installation procedure is identical for the
9. four cylinder and the three cylinder engines. The
10. illustration shows the four cylinder engine.
11. g01011111
12. Illustration 10
13. Typical example
14. 1. Thoroughly clean all of the inner surfaces of the
15. cover (1) for the fuel injectors.
16. 2. Install the cover (1).
17. 3. Install the setscrews (2) for the cover (1). Tighten
18. the setscrews (2) to a torque of 9 N·m (7 lb ft).
19. i01940997
20. Fuel Injection Pump - Remove
21. (Delphi DP210)
22. Removal Procedure
23. Start By:
24. a. Remove the fuel injection lines. Refer to this
25. Disassembly and Assembly Manual, “Fuel

Source: manual:Perkins-1103-1104-Series-Workshop-Manual.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.