Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Disassembly and Assembly, “Inlet Manifold

Perkins — Disassembly and Assembly, “Inlet Manifold

A Perkins service procedure — check it applies to your exact model before use.

Browse Perkins generators & specs →

Procedure

  1. 1. Ensure that all mating surfaces are clean and free
  2. 2. Place a new gasket (10) (not shown) in position
  3. 3. Position inlet manifold (7) on the cylinder head.
  4. 4. Install fasteners (8). Ensure that the brackets that
  5. 5. Tighten fasteners (8) to a torque of 55 N·m
  6. 6. Install a new O-ring seal (9) to inlet manifold (7).

Source: manual:Disassembly and Assembly-SM-PERKINS 2200 SERIES 2206-E13 INDUSTRIAL ENGINE.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.