Perkins — Camshaft - Remove and Install
For these Perkins models: 1103, 1103 Engine, 1104, 1104 Engine, 1104 Turbocharged Engine, SEBU7833-01.
Applies to: Perkins 1104
Before you start
- NOTICE: Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.
- NOTICE: Do not damage the lobes or the bearings when the camshaft is removed or installed.
- Note: Ensure that the camshaft (3) is clean. Lubricate the camshaft (3) with clean engine oil prior to installation.
Procedure
- Start By: a. Remove the cylinder head if the cylinder head has not previously been removed. b. Remove the front housing if the front housing has not previously been removed.
- Removal 1. Turn the engine upside-down so that the cam followers are held in a position away from the camshaft.
- Removal 2. Remove the thrust washer (1) if the thrust washer has not previously been removed. Make a note of the location of the hollow dowel (2) for installation purposes.
- Removal 3. Carefully remove the camshaft (3) from the cylinder block.
- Installation 1. Carefully install the camshaft (3) into the cylinder block.
- Installation 2. Put the thrust washer (1) in position if this is the appropriate time. Make sure that the thrust washer (1) is aligned with the hollow dowel (2).
- End By: a. Install the front housing if this is the appropriate time. b. Install the cylinder head if this is the appropriate time.
Source: manual:Perkins 1100 A-B-C- Series.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.