Perkins 900 Series — To remove and to fit the fuel lift pump

Repair & overhaul · Fuel system

For the Perkins 900 Series, from the Perkins service manual.

Applies to: Perkins 900 Series CP/CR engine

Procedure

1. Disconnect fuel pipes from fuel lift pump.
2. Release setscrews, remove lock plates and remove fuel lift pump.
3. Ensure camshaft eccentric is in minimum lift position before fitting.
4. Clean joint face and fit lift pump with new joint.
5. Fit lock plates and setscrews; tighten to 22 Nm (16 lbf ft) 2,2 kgf m.
6. Connect fuel pipes.
7. Release vent screw on fuel filter head and operate priming lever until fuel free of air.
8. Tighten vent screw; operate engine and check for leakage.

Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Perkins repair guides →