Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Perkins›Battery - Replace

Perkins 1506 — Battery - Replace

Maintenance

For the Perkins 1506, from the Perkins owner's manual.

Applies to: Perkins 1506A engine, Perkins 1506C engine, Perkins 1506D engine

Before you start

  • Batteries give off combustible gases which can explode.
  • The battery cover should be removed before any servicing is attempted.

Procedure

  1. Switch the engine to OFF and remove all electrical loads; allow 2 minutes for diesel exhaust fluid lines to purge before disconnecting power.
  2. Turn off and disconnect any battery chargers.
  3. Ensure the battery disconnect switch is in the OFF position.
  4. Disconnect the NEGATIVE "-" cable from the NEGATIVE "-" battery terminal.
  5. Disconnect the POSITIVE "+" cable from the POSITIVE "+" battery terminal.
  6. Remove the used battery and install the new battery.
  7. Connect the POSITIVE "+" cable to the POSITIVE "+" terminal.
  8. Connect the NEGATIVE "-" cable to the NEGATIVE "-" terminal.
  9. Turn the battery disconnect switch to ON.

Specs & values

  • After the engine has stopped, allow 2 minutes for diesel exhaust fluid lines to purge

Source: Perkins owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Perkins repair guides →