Perkins 1106D Industrial Engine — Fuel Transfer Pump - Remove
Repair & overhaul
For the Perkins 1106D Industrial Engine, from the Perkins service manual.
Applies to: Perkins 1106D engine
Before you start
- Ensure all fuel system work is performed by authorised personnel with correct training.
- Cleanliness of fuel system components must be observed during ALL work on the fuel system.
Procedure
- Isolate the fuel supply.
- Place a suitable container below the fuel transfer pump.
- Remove the plastic tube assembly from the fuel transfer pump.
- Disconnect the plastic tube assembly from the pump outlet.
- Remove connector and O-ring seal; if needed remove the other connector and O-ring seal.
- Remove the fuel return tube assembly from the transfer pump and cylinder head.
- Remove the engine oil supply tube assembly from the fuel injection pump.
- Plug or cap all open ports and tube assemblies immediately.
- Use an allen wrench with a ball end to remove allen head screws securing the pump.
- Remove fuel transfer pump from the fuel injection pump.
- Remove the O-ring seal from the fuel transfer pump.
Tools required
- Allen wrench with a ball end Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Perkins 1106D engine →
Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.