Perkins 1106D Industrial Engine — Fuel Priming Pump - Remove and Install (Electrical Priming Pump)
Repair & overhaul · Fuel priming pump (electric)
For the Perkins 1106D Industrial Engine, from the Perkins service manual.
Applies to: Perkins 1106D engine
Before you start
- Ensure all fuel system work is performed by authorised personnel with correct training.
- Cleanliness of fuel system components must be observed during ALL work on the fuel system.
Procedure
- Isolate the fuel supply.
- Isolate the electrical supply.
- Disconnect harness assembly for the electric priming pump.
- Mark plastic tube assemblies for correct position.
- Disconnect plastic tube assemblies; plug with new plugs and cap ports.
- Remove bolts from the electric priming pump.
- Remove electric priming pump from the mounting bracket.
- Position electric priming pump on the mounting bracket and install bolts.
- Tighten bolts to 9 N·m (79 lb in).
- Remove plugs and caps; connect plastic tube assemblies in original positions.
- Connect harness assembly for the electric priming pump.
- Restore electrical supply and fuel supply.
- Prime the fuel system.
Specs & values
- 9 N·m (79 lb in)
Full service-parts list: Perkins 1106D engine →
Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.