Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Perkins›Fuel Filter Base - Remove and Install (Secondary Fuel Filter)

Perkins 1106D Industrial Engine — Fuel Filter Base - Remove and Install (Secondary Fuel Filter)

Repair & overhaul

For the Perkins 1106D Industrial Engine, from the Perkins service manual.

Applies to: Perkins 1106D engine

Before you start

  • Ensure the plastic tube assemblies are installed in the original positions.
  • Failure to connect tube assemblies to correct ports allows contamination to enter the fuel system causing serious engine damage.

Procedure

  1. Isolate the fuel supply.
  2. Mark plastic tube assemblies for correct position.
  3. Place container below the fuel filter base.
  4. Disconnect plastic tube assemblies; plug with new plugs and cap ports.
  5. Remove fuel filter.
  6. Remove bolts from the fuel filter base and remove from mounting bracket (do not disassemble base).
  7. Position fuel filter base on mounting bracket and install bolts; tighten to 44 N·m (32 lb ft).
  8. Remove plugs and caps.
  9. Connect plastic tube assemblies to the base in original positions.
  10. Install a new fuel filter if needed.
  11. Restore fuel supply.
  12. Remove air from fuel system (prime).

Specs & values

  • 44 N·m (32 lb ft)

Full service-parts list: Perkins 1106D engine →

Source: Perkins service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Perkins repair guides →